Electronics Information #2 - ASVAB Advantage

Question 1 of 50

Which of the following is the most conductive element?

Gold
Silver
Aluminium
Copper

Question 2 of 50

Which of the following statements is correct?

Conventional current flows from positive terminal of the source to its negative terminal through the circuit.
Electron current flows from positive terminal of the source to its negative terminal through the circuit.
Conventional current flows from negative terminal of the source to its positive terminal through the circuit.
Both option A and B

Question 3 of 50

Which of the following statements are correct regarding a Voltmeter?

A voltmeter is used to measure current.
A voltmeter is used in parallel to a circuit.
A voltmeter must have the least resistance.
All of the above

Question 4 of 50

Which of the following instruments is used to measure resistance of a load?

Voltmeter
Ohmmeter
Ammeter
Galvanometer

Question 5 of 50

Which of the following statements is incorrect regarding Ohm’s Law?

Voltage is directly proportional to the current.
Voltage is inversely proportional to the resistance.
Current is inversely proportional to the resistance.
Voltage is directly proportional to both current and resistance.

Question 6 of 50

How much current will flow through the resistor R2 if R1=R2=10 ohms and R3=20 Ohms?

1.5 amperes
3 amperes
4 amperes
6 amperes

Question 7 of 50

If three different resistors are connected in parallel and a voltage is applied across them, which of the following statements is correct?

The smallest resistance has the least power loss across three resistances.
The greatest resistance has the maximum power loss across three resistances.
Both the smallest and the greatest resistances have the same power losses.
The greatest resistance has the least power loss across three resistances.

Question 8 of 50

Four bulbs are connected in a series-parallel circuit as shown in the given figure. Each bulb is exhibiting a resistance of 4 ohms. If one of two bulbs in the parallel connection blows up, then what will the effect be on the total effective resistance offered by all the bulbs?

The total effective resistance will decrease.
The total effective resistance will increase.
The total effective resistance will remain same.
The circuit would be open.

Question 9 of 50

A microwave is consuming 800 W power using a standard North American 120 V power supply. What is the approximate amount of current flowing?

3 amperes
5 amperes
7 amperes
9 amperes

Question 10 of 50

Which of the following is a unit of power?

J/s
W
V.A
All of the above

Question 11 of 50

Which of the following is true regarding an AC signal?

The greater the time period, the greater the frequency.
The smaller the time period, the greater the frequency.
The time period of an AC signal is directly proportional to the square of the frequency.
There is no relation between the frequency and time period of an AC signal.

Question 12 of 50

A ground is not one of the following.

A place with a maximum resistance.
A place of lowest potential in a circuit.
A reference point in the circuit from which voltages are measured.
A common return path for electric current.

Question 13 of 50

What does the following image represent?

Fixed Resistor
Rheostat
Capacitor
Potentiometer

Question 14 of 50

A circuit breaker is better than a fuse because

Circuit breakers are less expensive.
A circuit breaker responds more quickly to an excessive current than a fuse.
A circuit breaker can be reused multiple times.
A circuit breaker is often not compatible with modern electric equipment.

Question 15 of 50

A capacitor blocks Direct Current (D.C). Hence, it is also known as a:

Blocking Capacitor
Switched Capacitor
Coupling Capacitor
Both Blocking and Coupling Capacitors

Question 16 of 50

How many valence electrons are present in most semiconductor materials?

4
5
6
7

Question 17 of 50

What is commonly used in a circuit in which the flow of electricity needs to pass easily in one direction but not the opposite direction?

Resistor
Diode
Capacitor
Inductor

Question 18 of 50

Which of the following is not an application of a transistor?

Electric Switch
Amplifier
Transformer
Current Regulator

Question 19 of 50

Which of the following statements is correct regarding inductors?

An inductor blocks AC but allows DC to pass.
An inductor blocks DC but allows AC to pass.
An inductors blocks both AC and DC.
An inductor allows both AC and DC to pass.

Question 20 of 50

In a transformer

The primary coil is the one that is connected to the source.
The secondary coil is the one in which an electric current is induced.
A larger number of secondary coils means a larger voltage.
All of the above

Question 21 of 50

Which of the following statements is correct?

A generator converts mechanical energy into electrical energy.
A motor converts electrical energy into mechanical energy.
A motor converts mechanical energy into electrical energy.
Both options A and B

Question 22 of 50

Which of the following statements is correct?

Atomic Number is the number of electrons present in any material.
Atomic Number is the number of neutrons present in any material.
Atomic Number is the number of protons present in the nucleus of any material.
Atomic Number is the number of protons and electrons present in any material.

Question 23 of 50

Current I is passing through a load of resistance R. If the voltage across the load doubles and the resistance of the load is reduced by half then what is the amount of current passing through the load?

0.5I
I
2I
4I

Question 24 of 50

Current flows:

From Higher Potential to Low Potential.
Towards least resistance.
Towards maximum resistance.
Both options A and B

Question 25 of 50

What is the total amount of energy if a 12 C charge produces 3 V?

0.25 J
4 J
12 J
36 J

Question 26 of 50

Copper is a good conductor of electricity because:

It has a high melting point.
It does not corrode.
It demonstrates a low amount of resistance.
It is inexpensive.

Question 27 of 50

What would happen to the voltage if the current doubles and the resistance increases four times?

The voltage will increase 8 times.
The voltage will increase four times.
The voltage will increase two times.
The voltage will remain same.

Question 28 of 50

A series circuit is shown in the figure. What is the voltage across resistor R3 if R1=20 ohms and R3=30 ohms?

6 V
9 V
12 V
15 V

Question 29 of 50

A parallel combination of two resistors is connected in series with a 4 ohm resistor. If the total effective resistance by these three resistors is 10 ohms then which of the following can be the values of two resistors in parallel connection?

Each resistor is of 6 ohms.
One resistor is of 12 ohms and the other is of 24 ohms.
One resistor is of 8 ohms and the other is of 24 ohms.
One ohm is of 16 ohms and the other is of 24 ohms.

Question 30 of 50

The electric power consumed by an electric kettle is 2000 W. If the voltage being supplied to the kettle increases 4 times and the current flowing through the kettle is decreased by half, what would be the effect on the power consumed by the kettle?

The electric power would remain the same.
The electric power would double.
The electric power would increase 4 times.
The electric power would increase 8 times.

Question 31 of 50

If two different resistors are connected in series, then which of the following statements is correct regarding the electrical power consumed by the resistors?

The power consumed by each resistor will be the same.
The resistor offering larger resistance will consume more electrical power.
The resistor offering smaller resistance will consume more power.
The power consumed by each resistor cannot be determined unless the current flowing through each resistor is given.

Question 32 of 50

What is the frequency of Direct Current (DC)?

0 Hz
50 Hz
60 Hz
100 Hz

Question 33 of 50

What does the following image represent?

Inductor
Transistor
Diode
Ground

Question 34 of 50

A resistor with a 100 ohms of resistance has 10% tolerance. What does this mean?

The resistor has a fixed resistance of 100 ohms.
The resistance may vary from 90 ohms to 110 ohms.
The resistance may vary from 90 ohms to 100 ohms.
The resistance may vary from 100 ohms to 110 ohms.

Question 35 of 50

An ideal fuse should have a:

High melting point and a low current rating.
Low melting point and a high current rating.
High melting point and a high current rating.
Low melting point and a low current rating.

Question 36 of 50

A fuse rated at 0.8 A blows when the switch is closed. If an 80 V supply is supplying power to the circuit, what would be the maximum possible value of the resistance for which the current flows through the circuit?

100 ohms
90 ohms
80 ohms
70 ohms

Question 37 of 50

Rectification is an important application of a diode. Rectification can be defined as:

The conversion of DC into AC.
Boosting AC.
The conversion of AC to DC.
Boosting DC.

Question 38 of 50

What are the three terminals of a transistor?

Ground, Emitter, Collector
Base, Emitter, Collector.
Base, Anode, Cathode.
Ground, Anode, Cathode.

Question 39 of 50

A capacitor stores energy in the form of:

Electric Field
Magnetic Field
Both Electric and Magnetic Fields
Neither Electric nor Magnetic Field

Question 40 of 50

What is the basic operation of a step-up transformer?

It steps up the voltage.
It steps down the current.
It steps up the current.
Both options 1 and 2

Question 41 of 50

The generated force on a current carrying wire can be increased by

Increasing the amount of current flowing.
Decreasing the length of the wire.
Decreasing the strength of the magnetic field.
All of the above

Question 42 of 50

A capacitor is also known as:

Inductor
Rectifier
Condenser
Switch

Question 43 of 50

Four capacitors are connected in parallel, each having a capacitance of 4 farads. What will be the equivalent capacitance of these capacitors?

4 F
16 F
2 F
1 F

Question 44 of 50

The electrical symbol in the figure represents which of the following?

Oscilloscope
Lamp (Lighting)
Galvanometer
Ammeter

Question 45 of 50

An inductor stores energy in the form of

Electrical field
Mechanical Energy
Magnetic field
Both electrical and magnetic fields.

Question 46 of 50

What does the following image represent?

Transistor
Diode
Heater
Transformer

Question 47 of 50

Which of the following statements is incorrect regarding a transformer?

The frequency does not change in transformation action.
A transformer has no mechanical losses.
Secondary current of a step-down transformer is less than its primary current.
The power on primary side of an ideal transformer is equal to the power on secondary side.

Question 48 of 50

Electrical power can be calculated with the following formula:

P = I × V

What does the letter I represent in this formula?

watts
voltage
current
impedance

Question 49 of 50

What is the load in this basic circuit model?

A
B
C
D

Question 50 of 50

Three amps equals how many milliamps?

0.003
30
300
3,000

Quiz Summary

Information

Results

Results

Categories

1. Question

2. Question

3. Question

4. Question

5. Question

6. Question

7. Question

8. Question

9. Question

10. Question

11. Question

12. Question

13. Question

14. Question

15. Question

16. Question

17. Question

18. Question

19. Question

20. Question

21. Question

22. Question

23. Question

24. Question

25. Question

26. Question

27. Question

28. Question

29. Question

30. Question

31. Question

32. Question

33. Question

34. Question

35. Question

36. Question

37. Question

38. Question

39. Question

40. Question

41. Question

42. Question

43. Question

44. Question

45. Question

46. Question

47. Question

48. Question

49. Question

50. Question

CONNECT WITH US

FEATURED BLOGS

How Many Times Can You Take The ASVAB?

How Long Is the ASVAB Test?

Can You Retake the ASVAB?

PRACTICE TESTS

Pass your ASVAB exam in one try. Guaranteed.